User's Manual

www.winnix.net
14
2.23 Tag Kill setting
In Tag Operate section, below is the picture for Tag Kill setting.
Picture 25 Tag kill setting
It is supported by ISO18000-6C protocol the reader could kill the tags permanently. Please
caution the killed tag could not be usable.
Tag Kill setting is usually operated with filter operation, which means you can kill the picked EPC
tags, and avoid killing un-picked tags. Steps are as following:
Find the tag on ‘Workspace’ which you want to kill, double-click the EPC number, enter ‘tag
operate’ interface, then you can operate.
2.24 FastID Function
Picture26 FastID Operation screen
Click“FastID”then you can start FastID function
When you open “FastID”， on single inventory and continuous inventory, the EPC and TID of
the tag will be shown together.
Attention, only if the tag support FastID function, then you can use this function, if the tag
didn’t support this function, you only can get EPC.