User's Manual

Hardware Installation for WR/ WT
1. Position the toggle switch to the same mode (SW/SP) on both WR and WT.
2. Connect power to 12V/1A and a monitor to display output on WR.
3. Connect WR and WT by the HDMI cable to pair. The STA signals
keep flashing until pairing completed.
4. After pairing, connect power to 12V/1A, a monitor for loopback, and a
device to input on WT.
5. For SW mode, please set WR and WT to the same channel ID. Every WT
under the same network should be set to different channel ID.
12V/1A
2
Power
WR
1
Monitor
SW
SP
RJ45
DC IN HDMI OUT AUX OUT
IR IN USB K/M
RS232
(SP mode)
4
Pairing
WT
(SW mode)
RJ45
DC IN
HDMI OUT
HDMI IN
AUX INIR OUT
USB PC
RS232
12V/1A
3
Power Monitor Device