User's Manual

Hardware Overview for WT
1
2
3
4
5
6
7
8
RJ45
DC IN
HDMI OUT
HDMI IN
AUX IN
IR OUT
USB PC
RS232
9
10 11 12 13 14 15 16
17
18 19
RST PWR LINK STA MODE
12ID1
24
8
SWSP
1. DC IN port: 12V/1A power supply is required.
2. HDMI OUT port: Connect to the monitor for loopback.
3. HDMI IN port: Connect to your device (laptop or computer).
4. AUX IN port: Input audio to replace that from HDMI source.
5. IR OUT port: Output IR signal for remote control.
6. RJ45 port: Connect to router or switch with LAN cable for bridge. Only for
specific settings like firmware upgrade and CMS system control.
7. USB PC: Connect to your computer to receive reverse control signals.
8. RS232: Output RS232 signal for remote control.
9. Reset hole: Long press to reset to factory default settings.
10. PWR light: Lighting when power is supplied.
11. LINK light: Lighting when Ethernet is connected.
12. STA light: Flashing when data is transmitting.
15. Mode 2 light (Channel bit): Light on indicates channel adjustment is for
high-bit channel, while light off indicates channel adjustment is for low-bit
channel.
16. ID button: Click to switch channel ID, and long press to switch between
high-bit and low-bit channel adjustment (lighting for mode 2).
17. Channel signal: The channel number is the sum of what the light-on
signals represent.
18. Switch mode: Display the screen to WR with the same channel ID.
19. Splitter mode: Direct connection to WR for 1 to 1 extending display or 1 to N
multicast. No channel ID should be set.