User Manual WINIX AIR CLEANER Model Use & Care Guide C535 • Please read and follow all safety rules and instructions in this manual before operating. • The product warranty is printed on the back of this guide, so please keep it in a safe place for future use.
3-STAGE AIR PURIFICATION Odor Sensor PlasmaWave® Light Sensor Control Panel / Display Panel True HEPA Filter Odor Absorbing Carbon Filter Pre-Filter Power cord with plug (This product is suitable for 120V only.
CONTROLS Reset Button PlasmaWave® Indicator After replacing a filter, press the RESET button for at least 5 seconds. Indicates whether PlasmaWave® is enabled or disabled. Timer Indicator If timer has been set, the LED light indicates the set time of operation. Mode Button Press to cycle through and set the desired mode of operation (Auto, Sleep). Fan Speed 소피아 1 Indicator Indicates the current fan speed.
SAFETY AND CAUTIONS WARNING Follow these instructions to reduce the risk of serious injury or death and to reduce risk of damagin the unit. Before operating this equipment, carefully read and follow these safety cautions Ensure filters are inserted before running unit running unit without filters can shorten the units life and cause electric shock or injury. Be sure foreign objects are NOT inserted into the vents on the unit objects can include pins, rods, and coins.
INSTALLING FILTERS This product comes with all the required filters. The protective plastic wrap must be removed from the filters before use. • Operating the unit without removing the plastic wrap may result in product failure. • Unplug and make sure the unit is turned off before installing filters. Remove the front panel by grasping its upper edge and gently pulling forward. Latch Remove the filters from the unit. They are protected inside a plastic wrap.
Replace the front panel by first inserting the latch at the bottom edge into the base of the unit, then rotate the panel upward toward the top of the unit until the magnets pull the lid closed. When to Replace Filters When the Check Filter indicator LED is on, it is time to replace the True HEPA Filter. Latch Odor Absorbing Carbon Filter True HEPA Filter The filters’ life varies depending on the level of particles in the air.
INITIAL OPERATION I nsert the power cord into an electrical outlet. Press the "Power" button. During the first 30 seconds of power up, the Air Quality Indicator will cycle through Blue, Amber and Red colors. 소피아 1 Smart Sensor (Odor Sensor) takes approximately 4 minutes to gauge the air quality in the environment before normal operation begins. 소피아 1 et desired fan speed by S using Auto or Manual Mode. By default, when the unit first powers on, the mode will be set to Auto with PlasmaWave® enabled.
FEATURES PlasmaWave® By default, PlasmaWave® is enabled whenever the unit is powered on. • • • Press the Plasmawave button, when the unit is on, to enable or disable this feature. PlasmaWave® works to remove harmful airborne contaminants. When the unit is running, you may hear a chirping or buzzing sound. The sound is from large particles passing through PlasmaWave®, it is normal and does not signify product failure.
REPLACING FILTERS Remove Used Filters Turn the unit power off before removing filters. 1 2 3 Tabs Latch ▶ ▶ Pre-Filter Remove the front panel by grasping its upper edge and gently pulling forward. Press on the Pre-Filter tabs near the top of the filter, release and remove. Pull out the Odor Absorbing Carbon Filter and True HEPA Filter. Prepare New Filters Remove filters from protective plastic wrap.
CLEANING CARE Cleaning the filters Use a vacuum cleaner or soft brush to clean the Pre-Filter. • If it is excessively soiled, rinse in room temperature water. • Do not use detergent or soap. • Allow the filter to dry for 24 hours or more before using. • Intervals between filter cleaning may vary depending on the air quality. - Do not use benzene, alcohol, or other volatile fluids, which may cause damage or discoloration.
REMOTE CONTROL Operates in a 20 foot radius. ( A ) Power: Turns the unit on or off. ( B ) Auto: Enables Auto Mode. ( C ) Fan Speed: Enters into Manual Mode while selecting Fan Speed. ( D ) Turbo: Enters Manual Mode setting device directly to Turbo Fan Speed. Cradle Wall mountable storage cradle. Battery Replacement Insert the pin into the hole on the bottom of the remote control. Using the pin, pull the battery cover out and remove the old battery. 1 Back 4 Insert new battery, with PLUS side up.
FREQUENTLY ASKED QUESTIONS Problem Check / Actions to take It does not turn on at all. • Is the plug securely attached to the outlet? - Make sure the outlet has power going to it, and ensure the plug is secured. • Is there a power outage? - Check to see if other lights and electrical equipment are working and try again. It doesn’t work in Auto Mode. • Has Auto Mode been selected? - Press the Mode button until Auto Mode is selected.
UNIT SPECIFICATIONS Model Name C535 Power Voltage AC120V / 60Hz Power Rate 70W Verified Room Size 360ft2 Dimensions 14.9 in(W) x 23.6 in(D) x 7.8 in(H) Weight 14.7 lbs Replacement Filter Filter A / Item: 115115 The exterior, design, and product specifications may be changed without prior notice to improve product performance.
SAFETY INSTRUCTIONS Thank you for purchasing a Winix air purifier. This product is for household use only. IMPORTANT CAUTIONS FOR USING YOUR AIR PURIFIER WARNING: Follow the instructions in this manual to reduce the risk of electric shock, short circuit, and/or fire. • Do not repair or modify the unit unless specifically recommended in this manual. All other repairs should be completed by a qualified technician. • The plug for this unit is polarized with one blade wider than the other.
PRODUCT WARRANTY The terms of the warranty are as follows. 1. This product is manufactured under stringent quality control and inspections. 2. Warranty void if product failure is a result of negligence or misuse by the consumer, shipping and service fees may be incurred even during the warranty period. 3. The warranty must be presented upon bringing the product for service. 4. Store the warranty in a safe place, as it cannot be reissued. 5. This warranty is valid only in the USA and Canada.
Developed in partnership with Drexel University (Philadelphia, PA, USA) 2610-0227-00 Rev.00 Contact for product related inquiries and customer service To expedite service, please specify the model name and number, the nature of the problem, your contact information, and your address. Dedicated Call Center : (877) 699-4649 Website : www.winixamerica.
