Specification

Continue cutting horizontally
through drain flange to
weaken it, but not deep
enough to damage pan.
With hacksaw, make two
vertical cuts approximately
1” apart through drain body.
Cut completely through
drain body without cutting
into shower pan or scoring
pipe riser.
#4208 - 6 IN 1 Screwdriver
Removing Drain Seal - 2 Part System
(Threaded Nut & Gasket Type)
WingTite Installation
Removing Drain Seal - 3 Part System
(AB&A Sure Fit)
Insert drywall screws into opposite sides of ring-gasket and split
ring removing one at a time exposing 2” pipe riser & drain body.
Extract the compression gasket assembly exposing 2” pipe riser
and drain body by unthreading compression nut and pulling gasket
out with needle nose pliers.
Remove drain cover with
flat blade screwdriver.
Remove drain cover with
flat blade screwdriver.
Squeeze the shower drain to collapse it, this allows the retaining nut
below shower base to drop. Nut stays below.
Remove shower drain from pan. Clean shower surface around
drain hole, above and below the pan to insure proper seal and
unrestricted wing movement.
Once horizontal flange is cut, use flat blade screwdriver
to pry on 1” flange to break free from shower pan.
Remove 1” width of the drain body from pan.
Liquid Dish Soap
100% Silicone Sealant
DO NOT TIGHTEN
PHILLIPS HEAD
WING SCREWS WITH
POWER TOOLS !!!
Insert drain into shower pan and
press evenly over 2” drain pipe.
Once drain has made contact with
shower pan, hold firmly in place.
Inspect pipe riser to ensure full
contact with O-ring seal.
Tighten all four Phillips head wing
screws evenly until drain is secure
in pan. 20 Inch pounds maximum!
Apply liquid dish soap
to drain O-ring as lubricant.
Apply a generous amount
of 100% silicone to underside
of WingTite drain flange.
We Sell Adapters for the Pipe Sizes Below
To Order Call [phone]
#4290 Mini Saw
PASCOSpecialty&Mfg.,Inc.
Since 1936
11156WrightRoad•P.O.Box1747•Lynwood,CA90262-1247
Phone:310-537-7782•Fax:310-537-5065
7529PerrymanCourt•CurtisBay,MD21226-1752
Phone:410-360-5010•Fax:877-377-6466
www.pascospecialty.com