Installation Manual

The modular transmitter is only FCC authorized for the specific rule parts (i.e., FCC

transmitter

rules) listed on the grant, and that the host product manufacturer is responsible for

compliance to

any other FCC rules that apply to the host not covered by the modular transmitter grant of

certification. If the grantee markets their product as being Part 15 Subpart B compliant

(when it also

contains unintentional-radiator digital circuity), then the grantee shall provide a notice

stating that

the final host product still requires Part 15 Subpart B compliance testing with the modular

transmitter installed.

This device is intended only for OEM integrators under the following

conditions: (For module device use)

1) The antenna must be installed such that 20 cm is maintained between the antenna and

users, and

2) The transmitter module may not be co-located with any other transmitter or antenna.

As long as 2 conditions above are met, further transmitter test will not be required.

However, the

OEM integrator is still responsible for testing their end-product for any additional

compliance

requirements required with this module installed.

Radiation Exposure Statement

This equipment complies with FCC radiation exposure limits set forth for an uncontrolled

environment. This equipment should be installed and operated with minimum distance 20

cm between the radiator & your body.