Installation Manual

11
7. Warning
Important Notice to OEM integrators
1. This module is limited to OEM installation ONLY.
2. This module is limited to installation in mobile or fixed applications, according to Part
2.1091(b).
3. The separate approval is required for all other operating configurations, including
portable configurations with respect to Part 2.1093 and different antenna configurations
4. For FCC Part 15.31 (h) and (k): The host manufacturer is responsible for additional
testing to verify compliance as a composite system. When testing the host device for
compliance with Part
15 Subpart B, the host manufacturer is required to show compliance with Part 15 Subpart
B while the transmitter module(s) are installed and operating. The modules should be
transmitting and the evaluation should confirm that the module's intentional emissions are
compliant (i.e. fundamental and out of band emissions). The host manufacturer must
verify that there are no additional unintentional emissions other than what is permitted in
Part 15 Subpart B or emissions are complaint with the transmitter(s) rule(s).
The Grantee will provide guidance to the host manufacturer for Part 15 B requirements if
needed.
End Product Labeling
When the module is installed in the host device, the FCC ID label must be visible through
a window on the final device or it must be visible when an access panel, door or cover is
easily re-moved. If not, a second label must be placed on the outside of the final device
that contains the following text: “Contains FCC ID: 2APXW-WM118”
The FCC ID can be used only when all FCC compliance requirements are met.
Antenna Installation
(1) The antenna must be installed such that 20 cm is maintained between the antenna and
users,
(2) The transmitter module may not be co-located with any other transmitter or antenna.