Tus neeg siv phau ntawv

Product Description

This product is a set of mobile phone, earphone,

watch in one of the three in one wireless charger,

It uses a folding position to charge the earphones,

while the watch can be charged by sliding cover

and push-pull mode, It also supports horizontal

and vertical charging. The design is small and

beautiful, especially suitable for home office use.

One end of the TPYE-C data line is inserted into

the input port of the product, and the other end is

connected to the charging head, so that the product

can be used normally.

1. Standby: power on the product, double green lights

flash out, in standby state

2. Earphone charging: Open the folded lower shell

and lay it flat,place the earphone that supports

wireless charging in the center of the charging

sign,the green light on the product will be turned

off after 20 seconds and then the earphone

charging indicator will be on until it is fully charged.

3. Watch charging: Slide right out of the top cover,

then place the watch that supports wireless

charging in the center of the charging sign mark

automatically adsorption, watch shows charging.

4. Mobile phone charging: Open the mobile phone

bracket, the mobile phone that supports wireless

charging can be placed horizontally or vertically

on the bracket, the green light under the product

will be on for 20 seconds, and the mobile phone

will display charging instructions until it is fully

charged.

1. This product need uses the recommended adapter

2. Avoid violent impact and falling.

3. Do not place it in direct sunlight, high temperature

and damp place.

4. Avoid using liquid or hard cloth with corrosive

chemical composition to wipe the surface of the

product.

PAGE 1
K1 Product Description This product is a set of mobile phone, earphone, watch in one of the three in one wireless charger, 1. Standby: power on the product, double green lights flash out, in standby state It uses a folding position to charge the earphones, while the watch can be charged by sliding cover K1 3. Watch charging: Slide right out of the top cover, then place the watch that supports wireless charging in the center of the charging sign mark 2.
PAGE 2
FCC WARNING This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.