Technical information

Never add fuel, hydraulic oil or lubricant to the machine while it is running.
Keep the area around the machine clear of obstructions which could cause
persons to fall onto moving parts.
Keep the body and clothing clear of all moving and hot parts.
Always ensure that during operation the mixer is standing on stable and level
ground and that the jack legs are securely in place.
Keep the engine/motor housing lid closed when the engine or electric motor
are running.
Towing speeds are not to exceed 5 m.p.h. (8 k.p.h.) Always tow on ground
that is level and stable.
ENGINE
Starting any diesel engine can be dangerous in the hands of inexperienced
people. Operators must be instructed in the correct procedures before
attempting to start any engine.
Always obtain advice before mixing oils; some oils are not compatible. If in
doubt, drain and refill.
The materials used in the manufacture and treatment of some filters and
elements may cause irritation or discomfort if they come into contact with the
eyes or mouth and they may give off toxic gases if they are burnt.
Engine lifting eyes must not be used to lift the complete machine.
Ether based cold start aids in aerosol cans must not be used under any
circumstances.
EXHAUST GASES CONTAIN CARBON MONOXIDE WHICH IS A
COLOURLESS, ODOURLESS AND POISONOUS GAS THAT CAN CAUSE
UNCONSCIOUSNESS AND DEATH.
ELECTRICAL SYSTEMS
Starting engines that are fitted with charge windings which have been
disconnected from the battery will cause irreparable damage unless the stator
leads from the rectifier/regulator have been removed.
The following points must be strictly observed when charge windings are fitted
otherwise serious damage can be done.
Never remove any electrical cable while the battery is connected in the
circuit.
Only disconnect the battery with the engine stopped and all switches in
the OFF position.
1.2 SAFE WORKING