Technical information

GREASE AND LUBRICATION
POINTS
Every day: All shafts and bearings
needing daily attention are lubricated
through drilled shafts and special
greaseways by fitting grease nipples.
The lubrication diagram will give you the
location of these grease nipples, which
should be greased daily, using a grease
gun charged with a good quality medium
grease.
It is essential that operators do not allow
grease or oil used for servicing to become
contaminated with sand or cement dust.
Every week: A little engine oil should be
applied to pin joints on clutch lever
linkage, and low level dragline pivots, etc.
Every month (or 100 hours): Lubricate
gear ring and roller track.
Use only recommended lubricants. (see
"Technical lnformation" section)
3.6 SERVICING