Technical information

.
INTRODUCTION
III
THE HANDBOOK MUST NOT BE REMOVED FROM THE MACHINE.
The Handbook must be kept clean and in good condition. Additional copies of the
Handbook can be obtained from your Distributor.
The contents of this Operator's Handbook are designed as a guide to the machine's
controls, operation, working capacities and maintenance. It is not a training manual.
Only trained operators should use this machine. Contact the C.I.T.B. or equivalent body
for advice on training.
THE HANDBOOK
The operator must read all the Handbook and fully understand its contents
before attempting to operate the machine.
In this Handbook are WARNING notes. They are preceded by this symbol:
These notes are used to indicate that the procedure being described in the
Handbook must be followed to avoid serious injury or death to yourself or to
others; or damage to the machine.
The warnings are also used to protect the machine from unsafe servicing
practices.
Pay particular attention to the warnings given in the Handbook. If you have any doubts
about any aspect of the machine's capability or servicing procedures, you must consult the
manufacturer.
The contents of this Handbook, although correct at the time of publication
may be subject to alteration by the Manufacturers without notice.
Winget Limited operate a policy of continuous product development.
Therefore, some illustrations or text within this publication may differ from
your machine.
IMPORTANT Engine change
From mid 2004 the Lister-Petter TS2 and TS3 engines were replaced by the Lister-
Petter TR2 and TR3 engines. The TR range of engines is completely interchangeable
with the TS range and consumable items such as filter elements are identical. There
are some internal component differences and when ordering spares it is important to
state whether it is a TS or TR engine.
Starting and maintenance instructions found throughout this Handbook which refer to
TS engines are also applicable to the TR engine.