Technical information

Operator’s book template
SERVICE SCHEDULE
The engine will require additional services or adjustments in addition to those listed below
(See the appropriate Engine Operator's handbook or Workshop Manual).
Every (8 hours)
Before work
Grease points Lubricate.
Engine Check fuel and lubricating oil levels.
Check for oil and fuel leaks.
Clean/replace air cleaner element under very dusty conditions.
(see also the relevant Engine handbook/workshop manual.)
After work
Mixer Wash down machine.
Drum and Hopper Thoroughly clean out the drum with water and gravel.
Water tank Drain if frost is expected.
Every week (40 hours). The above and the following
Dragline wire rope Check for wear and damage.
Drive chain Check tension, adjust if necessary.
Drive chain case Check oil level, top-up if necessary.
With the hopper down and the engine stopped:
Hydraulic oil Check level, top-up if necessary.
Dragline dynamo Check belt tension, adjust if necessary.
Controls & pivots Lubricate all levers, rods, pivots and pins.
Battery Check terminals.
Every month (100 hours). The above and the following
Hydraulic tank Check oil tank, filler and breather, clean if necessary.
Battery Check electrolyte level.
Drum drive Inspect and lubricate the drum track ring, gear,
idler rollers and edge rollers.
Every 3 months (300 hours). The above and the following
Engine Change air filter element.
Change lubrication oil and oil filter.
Change fuel filter.
(see also the relevant Engine handbook/workshop manual)
Every 6 months (600 hours). The above and the following
Gearbox Drain oil and refill.
Drive chain Case Drain oil and refill.
Every 12 months (1200 hours or earlier if conditions dictate).
The above and the following
Hydraulics Drain and clean out tank and suction strainer. Refill with new
hydraulic oil.
SERVICING 3.1