Technical information

Operator’s book template
CONTENTS
Section Page
INTRODUCTION
Introduction to the Handbook
III
Warranty Terms and Conditions
IV
Safe working 1.1
Decals 1.4
OPERATION
Re-assembly of mixer 2.1
Transportation of mixer 2.1
Anti-bounce gear 2.2
Installation on site 2.2
Pre-start check 2.3
Electric motor & engine operation 2.4
Water tank operation 2.8
Mixer controls and operation 2.11
Cleaning operations 2.13
Hose failure valve 2.13
Installation of Water Tank,
Dragline Winch & Cable Mast 2.15
SERVICING
Service schedule 3.1
General arrangement of mixer 3.2
Hydraulic system 3.3
Transmission 3.3
Drum clutch adjustment 3.4
Drive chain adjustment 3.4
Dragline feeder 3.4
Water tank and water pump 3.4
Batch weigher 3.4
Drum edge roller adjustment 3.4
Drive alignment 3.5
Dynamo belt 3.5
Bolt torques 3.5
Grease and lubrication points 3.6
Loadcell and weight gauge 3.7
Section Page
Engine (Lister-Petter TS)
Air filter 3.15
Oil filter 3.15
Lubrication oil 3.16
Fuel filter 3.17
Priming the fuel system 3.18
Battery 3.18
TS engines (electric start)
Fault finding 3.19
Voltage setting 3.19
Electrical systems 3.20 to 3.22B
Hour meter wiring 3.22
Hydraulic circuits 3.23 to 3.26
TECHNICAL INFORMATION
Lubricants 4.1
Noise levels 4.1
Fluid capacities 4.1
Mixing drum speed 4.1
Engine and motor speeds 4.1
Tyre pressures 4.1
Weights of mixers 4.1
Dimensions 4.2
PARTS
Illustrations of all mixer components.
II
INTRODUCTION