Installation & Assembly

3
LOCATION REQUIREMENTS
IMPORTANT: Observe all governing codes and ordinances. Have a qualified technician install the range hood. It is
the installer's responsibility to comply with installation clearances specified on the model/serial rating plate.
Canopy hood's location should be away from strong draft areas, such as windows, doors, and strong heating vents.
Cabinet opening dimensions that are shown must be used. Given dimensions provide minimum clearance.
ELECTRICAL REQUIREMENTS
Observe all governing codes and ordinances. Ensure that the electrical installation is adequate and in conformance
with the National Electrical Codes, ANSI/NFPA 70 (latest edition), or CSA Standards C22.1-94, Canadian Electrical
Code, Part 1 and C22.2 No. 0-M91 (latest edition), all local codes, and ordinances. If codes permit and a separate
ground wire is used, it is recommended that a qualified electrician determine that the ground path is adequate.
A copy of the above code standards can be obtained from:
1 Batterymarch Park
Quincy, MA 02169-7471
CSA International
8501 East Pleasant Valley Road
Cleveland, OH 44131-5575
➢ A 120 volt, 60 Hz., AC only, 15-amp, fused electrical circuit is required.
➢ If the house has aluminum wiring, follow the procedure below:
o Connect a section of solid copper wire to the pigtail leads.
o Connect the aluminum wiring to the copper wire using special connectors and/or tools designed
and UL listed for joining copper to aluminum. Follow the manufacturer’s recommended procedure
for the electrical connector. Aluminum/copper connection must conform to local codes and
industry accepted wiring practice.
➢ Wire sizes and connections must conform to the rating of the appliance as specified on the model/serial
rating plate. The model/serial plate is located behind the filter on the rear wall of the range hood.
➢ Wire sizes must conform to the requirements of the National Electrical Code, ANSI/NFPA 70 (latest edition),
or CSA Standards C22. 1-94, Canadian Electrical Code, Part 1 and C22.2 No. 0-M91 (latest edition) and all
local codes and ordinances.