Installation & Assembly

17
Powering on/off and Settings:
Lamp Timer Clock Fan Power/Standby
➢ Lamp: Press the lamp display one time to activate the light, press the lamp display again to deactivate it.
➢ Power/Standby: When the range hood is in the “original” state, touch this button. It will enter the
standby mode.
➢ Setting the clock: When the range hood is on “Standby” Mode, press and hold the timer button for 3
seconds. The range hood will then enter the time setting state; the display screen will show numbers.
Press the Fan button to set hours and press the Lamp button to set the minutes. After 10 seconds, it will
automatically exit the time setting state and the time you have entered will be saved, or press the Timer
button to exit and keep saved time.
➢ Fan Operation:
o In standby mode, press the Fan button one time and the range hood will start at F3 speed. If the
Fan button is pressed again, the speed will reduce to F2. If the Fan button is pressed again, the
speed will reduce to F1. Pressing the Fan button after the F1 setting will shut off the fan.
➢ Timer:
o When the fans are operating, touch the Timer button one time. This will turn on the timer mode
and the display with show a flashing 03:00, after 8 seconds the display will stop flashing and
begin counting down. Each time you press the timer button, it will increase by 1 minute with the
maximum timer setting of 60 minutes. Within the last 3 seconds of the timer setting, the range
hood will make three beeps.
o When range hood is on, touch the Power/Standby once and the shut off timer will set to 60
seconds. Touch the button twice and the fan will turn off.
Powering on/off the unit
➢ To turn the fan on push a button to select one of the 3 speeds:
o 2=High
o 3=Medium
o 4=Low
If you choose a new speed by pressing a different button, the new fan speed will replace the old fan
speed.
➢ To turn fan off push button 5.
➢ To operate light on/off push button 1. (Note: The fan and light operate independently of each other).
Powering on/off and Settings: