Installation & Assembly

14
23. Detach the outer duct cover (H) by removing the (2) set screws near the bottom middle of the attached duct.
Inside the duct, there are tongue and groove clips for stability. Lift on side of the duct to detach.
24. Bring the two duct pieces together over the support frame brackets and the upper duct that was attached in
step 15. Reattach the (2) set screws. Make sure the tongue and groove clips are realigned.
25. Set the bottom duct unto the top of the range hood in the grooved slot. Removing the filters, and from
underneath the range hood, screw in (14) #6 X 3/8 SM screws into the pre-drilled holes. This will secure the
outer duct to the range hood body.