Installation & Assembly

12
15. Place the range hood underneath the support frames and align the holes of the support frame to holes in the
range hood. Warning: This will take at least two people. Screw in (4) #6 X 3/8 SM screws through the
support frames into the pre-aligned holes in the range hood on all four corners.
16. Install (1) round flexible duct exhaust hose (F) to round vent air flap (C) (attached to range hood on top of
unit) and secure with duct tape. Note: If you are choosing the ductless/recirculating mode do not install
the duct exhaust hose (F).
17. Pull power cord (B) up through ceiling cut out and plug into outlet. You may need to access your ceiling. An
extension cord may be required. As electrical box locations may vary, please make proper accommodations
during the installation process.
18. Remove the tape from the outer duct cover from step 14. Lower the bottom duct unto the top of the range
hood in the grooved slot. Removing the filters, and from underneath the range hood, screw in (14) #6 X 3/8
SM screws into the pre-drilled holes. This will secure the outer duct to the range hood body. Go to operating
instructions.
(4) screws per corner