Installation & Assembly

One-piece seamless stainless-steel ducting Two-piece seamed stainless-steel ducting

For one-piece seamless stainless-steel ducting follow steps 12 through 18. For two-piece seamed stainless-steel

ducting go to steps 19 through 25.

12. Slip inner duct up through the support frames and over the ceiling mount bracket. Be sure the duct slides

over the (2) mounting brackets on each side.

13. The duct should cover the (2) mounting brackets on the sides of the ceiling bracket. Screw in (4) #6 X 3/8 SM

screws through the predrilled holes in the duct work into the 4 mounting brackets.

14. Slip outer duct cover through the support frames and temporarily over the inner duct. Apply tape to outer

duct cover to temporarily attach to the inner duct to hold in place while securing the range hood motor

assembly. After range hood motor assembly is attached you will remove the tape for final assembly of the

outer duct cover.

Note

Seam

Mounting brackets