\Dinette Bathroom Vanities INSTRUCTIONS FOR MODELS: BV30-A-WHT BV30-A-GRY BV30-A-ESP BV30-A-BLU IMPORTANT: READ AND SAVE THESE INSTRUCTIONS, FOR RESIDENTIAL USE ONLY.
Table of Contents Table of Contents. Safety Information Warranty. 5 Year Limited Warranty. What Is Covered What is Not Covered. Tools Require: Pr-assembly {continued).. Package Contents... bw en NNN BR Installation a on Maintenance. Care and Troubleshooting Safety Information DANGER Keep small parts away from children during assembly. Failure to follow warnings and cautions could resulting serious injury. Product is designed to hold 200 Ibs.
Pr-assembly Installation TOOLS REQUIRED {NOT INCLUDED) 1. Positioning the Vanity Combo >» Place the Vanity Combo(A) in the desired position considering the location of your plumbing. Safety Safety goggles gloves NOTE: Make sure the Vanity Combo{A) Is flush against wall. Measuring Marking EEE TE] DB tape Level | pen —_C— Silicon adhesive ( Pr-assembly (continued) ) 2. Attaching the Vanity Combo PACKAGE CONTENTS >» Remove Vanity Combo{A) away from desired location.
Installation 3. Backslash Attachment > > > Clean the backslash (B) of any residue. Apply the silicone adhesive to the back and bottom of the backslash} as shown below. Set the backslash {B} into place by pressing it firmly against the wall and vanity top so there are no gaps. Lethe adhesive cure for 24 hours before using the vanity. 4. Hardware Assembly » (A). Install the knobs on the vanity doors by using the (25mm) machine screw. >» {B).
