Installation Manual Automatic Multi-Satellite TV Antenna Model SK-SWM3 TRAV’LER® DIRECTV SWM Slimline Antenna ® www.winegard.com/mobile For Technical Services, email help@winegard.com or call 1-800-788-4417 For Receivers and Programming, call 1-866-609-9374 For up-to-date information on receiver compatibility and programming, visit www.winegard.
Before Installing the Antenna Clearance Requirements You have selected the Winegard® TRAV’LER® automatic multi-satellite TV antenna. The TRAV’LER antenna will deliver the ability to view multiple satellites at the same time with unmatched signal strength, the lowest travel height on the market, maximum HD capabilities and easy to use functionality—just like you get at home. This manual provides important information on the installation and operation of your TRAV’LER antenna on an RV.
Choosing a Location for the Antenna Installing the Antenna 1. For best performance and to reduce signal acquisition time, park the vehicle on a level surface that is free of obstructions such as trees or large buildings. Make sure you have a clear view of the southern sky. 1. Place the TRAV’LER antenna on the roof where you plan to install it. On the mount base, the transition plate is marked “FRONT” and “BACK.” Rotate the TRAV’LER antenna until the front of the mount base faces the front of the RV.
Overall Setup Setup Option 2 Choose between Setup Option 1 and Setup Option 2 to connect all cables. Only port C should be used for making connections to the mount base. Multiple receivers will connect to the mount base via the provided splitter; ports A and B will not be used. NOTE In Setup Option 1, a cable runs from the TRAV’LER antenna to the power inserter and from the power inserter to the splitter; cables then run from the splitter to each receiver (see fig. 8).
Installing the Reflector, Cont. 1. Press “POWER,” and hold for two seconds to turn on the interface box. Wait until the interface box finishes “connecting to antenna.” The TRAV’LER antenna may enter the search routine after ten seconds. Pay attention to the pinch points as the antenna raises. 2. As the antenna raises, press “POWER” and “SELECT” at the same time. The antenna should stop moving. 3. Line up the four holes on the reflector with the four holes on the mounting bracket.
Operation Manual Automatic Multi-Satellite TV Antenna Model SK-SWM3 TRAV’LER® DIRECTV SWM Slimline Antenna ® www.winegard.com/mobile For Technical Services, email help@winegard.com or call 1-800-788-4417 For Receivers and Programming, call 1-866-609-9374 For up-to-date information on receiver compatibility and programming, visit www.winegard.
Operation DIRECTV HD Receiver Setup The TRAV’LER antenna offers a simple one-button operation. Simply press “POWER,” and the antenna will automatically begin searching for satellites. The instructions assume that the antenna is already in the stowed position. The following instructions assume that the TRAV’LER antenna has found and locked onto satellites 99°, 101°, and 103°. There should be an asterisk next to 99°, 101°, and 103° on the TRAV’LER interface. 1.
Troubleshooting ANTENNA CONNECTION FAILED Check the data cable connection on the back of the interface box. It may not be connected properly. EL HOME FAILURE Something is preventing the mount from raising as it attempted to find the HOME position. Look for obstructions if the unit has recently been manually raised or if the electronics have been replaced. The calibration may need to be reset. Contact Winegard Technical Support at help@winegard.com or 1-800-788-4417.
