Automatic Multi-Satellite TV Antenna Replacement LNB Instructions for Models RP-SK01, RP-SK05, RP-SK09, and RP-SK73 For help, email help@winegard.com or call 1-800-788-4417 www.winegard.
Raising the Antenna 1. Press and hold “POWER” for two seconds to turn on the interface box. Wait until the interface box finishes “connecting to antenna.” The TRAV’LER® antenna may enter the search routine after ten seconds. Pay attention to the pinch points as the antenna raises! 2. Wait until the antenna has at least raised to a position in which the feed arm is parallel to the roof. Then, press “POWER” and “SELECT” at the same time. The antenna should stop moving. 3. Unplug the interface box.
Model RP-SK73 Shaw Direct Replacement LNB 1. Remove and set aside the four nuts and bolts holding the LNB guard to the feed arm. Then, remove the LNB guard from the feed arm. 2. Remove and set aside the screw holding the LNB to the feed arm. 3. Disconnect the four coax cables from the LNB using a 7/16” wrench, and carefully remove the LNB from the feed arm. 4. Connect the four cables running through the feed arm to the four ports on the replacement LNB. The cables can be connected in any order.
