Omnidirectional TV/FM Antenna For Technical Services, email help@winegard.com or call 1-800-788-4417. DO NOT RETURN ANTENNA TO PLACE OF PURCHASE. DO NOT SNAP THE ANTENNA HEAD AND PEDESTAL TOGETHER PRIOR TO READING MANUAL.
Specifications Safety Recommendations Range of up to 35 miles* Models RS-3000 (white), RS-3035 (black) For VHF & UHF channels Models RP-RS30 (white) replacement head and RP-RS35 (black) replacement head are available. For outdoor use only Amplified Height: 7.6” Diameter of Antenna Head: 14.
Mounting Option 1 Mounting Option 1, Cont. If installing the antenna so that the cable enters the vehicle directly beneath the antenna, follow the steps below for Mounting Option 1. 12. Run a solid bead of sealant where the edge of the pedestal and gasket assembly meets the roof and over the screw heads. 13. Gently push the cable slack downward through the pedestal. 1. Make sure the ceiling area is clear underneath the chosen location for the antenna. 14.
Mounting Option 2, Cont. Mounting Option 2 If installing the antenna so that the cable enters the vehicle via a cable entry plate (sold separately), follow the steps below for Mounting Option 2. 12. While applying pressure, rotate the head until feeling the grooves in the head line up with the grooves in the pedestal. 1. Run coaxial cable from the power supply to the antenna via the cable entry plate. The antenna needs to be at least 8 inches from the cable entry plate.
Installing the Power Supply Warning: The power supply should be turned off when connecting cables. Indicator light Coaxial port for main TV On/Off button The power supply may be flush mounted in most standard electrical boxes. To flush mount, cut a hole in the wall to fit the box. Run two #12 wires between the wall plate and +12 VDC source, and route downlead cable to this location. Make a 12 volt connection to the power supply.
Troubleshooting Do not install couplers, splitters, etc. between the power supply and the antenna. Installation of any item on the downlead may cause a short in the system. The downlead supplies +12 VDC to the preamp in the antenna. WINEGARD MOBILE PRODUCTS LIMITED WARRANTY (2 YEARS PARTS; 1 YEAR LABOR) The power supply should be turned OFF when connecting/disconnecting cables to power supply and antenna but should be turned ON when testing for voltage.
Winegard Company • 3000 Kirkwood Street • Burlington, IA 52601 800-288-8094 • Fax 319-754-0787 • www.winegard.com • Printed in U.S.A. ©2011 Winegard Company Rev4 7/12 2452249 Winegard is a registered trademark of Winegard Company, and RoadStar is a trademark of Winegard Company. dtv.gov is not affiliated with Winegard Company.
