Replacement DISH® 1000 LNB Assembly www.winegard.com/mobile For Technical Services, email help@winegard.
Raising the Antenna Follow the steps below to raise the antenna for reflector, bracket, and LNB assembly removal. Pay attention to the pinch points as the antenna raises. See below. Top View Side View Pinch Point Pinch Point 1 Press [POWER], and hold for two seconds to turn on the TRAV’LER® interface box. Wait until the interface box finishes “connecting to antenna.” The TRAV’LER antenna may enter the search routine after ten seconds. 2 As the antenna raises, press [POWER] and [SELECT] at the same time.
Removing the Reflector and LNB Assembly 1 If converting a DIRECTV SWM Slimline antenna to a DISH TRAV’LER antenna, remove the power inserter and SWM splitter; these will not be used. 2 Remove the four reflector nuts and bolts, and remove the dish. Set the nuts and bolts aside. Reflector nut not shown 3 Disconnect the coaxial cables from the turret. Note that the D port will not be present on a SWM TRAV’LER antenna.
6 Remove the bolts holding the reflector bracket to the skew housing. Reflector bracket Skew housing NOTE If replacing a Slimline assembly with a DISH assembly, remove and set aside the stiffener plate inside the reflector bracket. Stiffener plate 7 Remove the LNB arm assembly, and set aside. NOTE If replacing a Slimline assembly with a DISH assembly, remove the four bolts from the adaptor plate, and remove the adaptor plate.
1 Align the four holes on the inside of the reflector bracket with the four marked holes in the adaptor plate. See image below for the holes to align with the reflector bracket and adaptor plate. The numbers on the reflector bracket and adaptor plate should match. 1 1 4 2 4 TIP 2 3 3 The bracket should be installed so that the LNB arm assembly is at the bottom of this plate. 2 Replace the supplied /16 Allen screws through these four holes, and tighten.
Setting the IDU for DISH 1000 1 Press and hold [POWER] for two seconds or until the TRAV’LER interface displays “POWER ON.” 2 Now that the power is on, release the [POWER] button. 3 Press and hold the [ENTER] button for two seconds.The TRAV’LER interface will ask if you wish to enter the User Menu. Press [SELECT] to choose “Yes”; then, press [ENTER]. 4 The User Menu consists of four choices: Search Mode, Diagnostics, Installation, and Exit.
If you had to raise the antenna with the emergency manual stow drive, follow the instructions below for calibrating the elevation motor. 1 From the installation menu, press [SELECT] to move the asterisk to “Calibrate EL”; then, press [ENTER]. 2 Press [SELECT] to move the asterisk to “Yes.” 3 Press [ENTER] to start the elevation calibration procedure. The LCD should now display “Calibrate EL In Progress.” 4 After a few moments, the TRAV’LER interface box will display “On EL Hard Stop?/Yes *No.
3 Place another two sheets of void fill in the cardboard box, and place the LNB on top of these sheets of void fill. 4 Position the LNB in the center of the box. Make sure the cables are still connected to the LNB. 5 Place two sheets of void fill in the cardboard box, and push these two sheets into the box so that they cover the LNB. 6 Place an additional two sheets of void fill in the cardboard box so that they form an ‘X’; close the box, and tape it closed. 7 Return the package to 3111 Kirkwood St.
