User Manual

PARTS
INSTALLATION: OUTDOOR
STEP 1. Run a coax cable (not included) through the L-pipe and adapter plate.
STEP 2. Connect the coax cable to the antenna head.
STEP 3. Use the four screws to fix the adapter plate to the antenna head.
STEP 4. - OPTION 1
Mounting against a mast, railing or wall: Connect the fixed foot to the surface,
& then secure the L-pipe using the U-bolt installation.
OPTION 2
Mounting on a roof: Connect the adjustable foot to the roof surface, and then
secure the L-pipe using the U-bolt installation.
INSTALLATION: INDOOR
STEP 5. Connect antenna-attached coax cable to the power inserter marked ANT.
STEP 6. Connect a coax cable to the power inserter marked TV and then connect
it to the TV itself.
STEP 7. Turn on the power inserter by attaching the USB cable and connecting
it to the TV directly. Or, use the 110V power adapter.
STEP 8. Switch on the TV, run a channel scan, and start watching free TV.
TIP: If using a splitter to distribute signal to more than one TV, connect the USB
cable to the 110V power adapter instead of the TV USB port.
TIPS:
If splitting the signal to multiple TVs or combining with another signal source, it is
strongly recommended that the power inserter be installed between the antenna
and the splitter/combiner input. In this case, the cable connection from the “TV”
jack of the power inserter goes to the splitter input or valid combiner input. Use
splitters rated from 54-806 MHz or wider bandwidth (commonly 5-1000 MHz)
for over-the-air television signal distribution.
Additional distribution/inline amplifiers must be installed FOLLOWING the TV
output of the power inserter, NOT on the downlead cable line connecting to the
ANT/AMP port. Check TV picture quality and antenna alignment prior to adding
additional line amplifiers.
A maximum antenna-to-power inserter length of 150 feet RG-6 or 150 feet
RG-59 is acceptable.
Antenna Head
with Integrated
Amplifier
(x3)
Hardware Bag
Power Inserter
Adjustable
Foot
Fixed Foot
Adapter Plate
Metal L-Pipe
ANT/AMP
USB
PWR
TV/TUNER
Locking NutWasher
Mast Clamp
Mast Clamp
NOTE: (x2 Bolts Needed)
One bolt connects the
L-pipe to the fixed foot and
the other bolt connects the
adapter plate to the L-pipe
NOTE: (x3 Bolts Needed)
2 bolts are used to connect the
L-pipe to the adjustable foot
and the other bolt connects the
adapter plate to the L-pipe
4 Screws
4 Screws
Locking Nut
Locking Nuts
Locking Nut
Regular Nut
U-Bolt
U-Bolt
(x4)
(x4)
(x3)
(x4)
(x2)
(x2)
USB Cable
&
110V Power
Adapter