Information Sheet

ManualsBrandsWinegard ManualsOtherHD7698P

1450292

Rev6 7-19

VHF/UHF MODELS

HD7698P & HD8200U

High Deﬁnition VHF/UHF Antennas

INSTRUCTION MANUAL

For help, email help@winegard.com

HD7698P

HD8200U

WARNING

Installation of the antennas near power lines is dangerous!

For your safety, follow the installation instructions.

POINT THIS END

TOWARD STATIONS

POINT THIS END

TOWARD STATIONS

Summary of content (4 pages)

PAGE 1
VHF/UHF MODELS HD7698P & HD8200U High Definition VHF/UHF Antennas INSTRUCTION MANUAL PO TOW INT TH ARD IS E STA ND TIO NS HD7698P POINT T HIS EN TOWAR D D STATIO NS HD8200U Register your product at winegard.com/myantenna For help, email help@winegard.com WARNING: Installation of the antennas near power lines is dangerous! For your safety, follow the installation instructions.
PAGE 2
PARTS LIST FIGURE 1 Front Assembly TOOLS REQUIRED (not included) Corner Reflector Assembly (2) Rear Assembly Cartridge Housing Flat Head Screwdriver Phillips Screwdriver Crescent Wrench or Pliers Boot Mast Clamp Boom Brace Mast Clamp ASSEMBLY STEP 1 - Contents of Package A. Remove all parts from the box and compare to parts list to ensure nothing is missing and to become familiar with the part names. See FIGURE 1. NOTE: Unfolding elements procedure is the same for both HD7698P & HD8200U antennas.
PAGE 3
STEP 4 - Attaching Front Section to Rear Section FIGURE 4 - Front Section to Rear Section A. Slide the front boom into the rear boom making sure to feed the UHF phasing lines into the holes near the top of the cartridge housing, and into the slotted pegs inside the housing. See FIGURE 4. When finished, the phasing lines will be resting in the slots of the pegs, but will not extend out the back side of the cartridge housing. Cartridge Housing UHF Phasing Lines B.
PAGE 4
FIGURE 8 - Installing Coaxial Cable STEP 8 - Coaxial Cable A. Slide the rubber boot over the end of the coaxial cable. B. Attach the F-connector to the coaxial cable. C. Attach the coaxial cable to the cartridge housing. See FIGURE 8. D. Slide the boot over the boot collar on the housing. Attach coaxial cable with boot NOTE: If your coax cable has factory connectors on it, clip small end of boot off, so boot will slip over connector.