Instruction Manual

安装远程界面控制器（可选）

Mounting the Optional Remote Interface Controller

1.将远程界面控制器背面的通信电缆拔出。（图1）

Fig. 2

Disconnect the communication cable from the back of

Remote Interface Controller. (Fig. 1)

a)将通信电缆从墙上或天花板上接到控制器的

安装地点。

a) Install the communication cable within the wall

and/or ceiling structure of the wine cellar to the

desired controller mounting location.

b)将远程界面控制器安装在坚固表面上，注意要远离

门、角落、出气口、通风口或加热设备。请勿将控

制器直接安装在锅炉房外墙或紧邻锅炉房的墙上。

b) Mount the remote interface controller on a solid surface

away from doors, corners, air outlets, drafts or heat

generating equipment. Do not mount the Remote

Interface Controller directly on an outside wall or wall

adjacent to a boiler room.

2.拆下控制器背板，在安装位置上做好标记。（图2）

2. Remove the back plate of the controller and mark the

mounting points at the desired location. (Fig. 2)

标记出通信电缆通过的地点，准备钻孔。墙孔直

径应足够安装控制器后盖，以3.8毫米左右为

宜。（图3）

a) Mark the location of the communication cable

connection as this area will require sufficient

clearance for instance, a 3.8mm hole in the wall for

flush mounting of the back plate. (Fig. 3)

Fig. 1

Fig. 3