Use and Care Manual

1. ZONE SELECT (Dual Zone Only): Use to select the upper or lower zone when

setting the temperature, Press and hold to Unlock the control panel.

2. LIGHT: Turns the interior light ON and OFF. Press and hold the LIGHT button

for 2 seconds to toggle the LED display between Celsius or Fahrenheit

readings.

3. Upper Zone Temperature Display (Dual Zone).

4. Lower Zone Temperature Display (Dual Zone).

5. Temperature UP, the temperature increases 1°F each time the + button is

pressed.

6. Temperature DOWN, the temperature decreases 1°F each time the - button

is pressed.

7. Lock (Single Zone): Press and hold for 2 seconds to Unlock the control panel

8. Temperature Display (Single Zone).

Before You Start

The wine cellar should be placed in a location where the ambient temperature is

between 61° and 90°F. If the ambient temperature is above or below this range,

the performance of the unit may be affected. For example, placing your unit in

extreme cold or hot conditions may cause interior temperatures to fluctuate.

Setting the Temperature Control

NOTE: The temperature readout shows the actual cellar temperature, it will

temporarily show the set temperature while making adjustments, then reverts

back after 5 seconds.

1. Make sure power cord is connected to a properly grounded outlet.

2. Turn power ON.