User Manual

1. Pry up the hinge cover (1) and hinge cap (2) using a flat head screwdriver.

Using a Phillips head screwdriver, loosen the hinge screws (3a) and remove

the top hinge (4). You can now lift the door (5) off the bottom hinge and set

it off to one side. Be careful not to lose the washer (11) between the

bottom hinge and the door. You will need this later. Also remove lock hole

cap (6) and screws (7) and (8) from the top of the door. The lock cap can

be pried up using a small flat head screwdriver.

2. Using a Phillips head screwdriver, loosen screws (3b) to remove the hinge

support rod (9) at the bottom of the door. Rotate the door 180° so that the

top is now the bottom and vice versa. Attach the bottom hinge support rod

(9) to the bottom corner of the door and attach with screws (3b).

3. Using a flat head screwdriver, pry off the bottom hinge cover (12). Using a

Phillips head screwdriver, loosen and remove screws (3c) and (13) and

bottom hinge (10).

4. Move bottom hinge (10) to the opposite side and re-insert all screws (3c)

and (8). Bottom hinge cover (12) should clip back onto the bottom hinge.

5. Place the washer (11) over the hinge support rod (9) and place the door

back on the bottom hinge by aligning the hinge support rod (9) with the

outer hinge hole on bottom hinge (10).

6. Re-attach top hinge (4) using screws (3a). Insert lock cap (6), screws (7)

and (8), and clip on hinge cap (2).

Installing the Handle

1. Pull back the door seal behind handle location.

2. Insert screws into pre-drilled screw holes.

3. Attach handle and tighten screws.

4. Press door seal back into place.