manual

Before You Start

The wine cellar should be placed in a location where the ambient temperature is between

60-80° Fahrenheit. If the ambient temperature is above or below this range, the

performance of the unit may be affected. For example, placing your unit in extreme cold

or hot conditions may cause interior temperatures to fluctuate.

Setting the Temperature Control

NOTE: The temperature readout shows the actual cellar temperature, it will

temporarily show the set temperature while making adjustments, then reverts

back after 10 seconds.

1. Make sure power cord is connected to a properly grounded outlet.

2. Turn power ON.

3. Use the Zone Select to select the Upper or Lower zone.

4. Set the desired temperature by pushing the UP or DOWN button.

5. Temperatures increase or decrease 1°F with each push of the UP or

DOWN button.

6. Upper zone must be set 4°F colder than lower zone.

7. The control panel will ‘sleep’ after left untouched for 10 seconds. Touch

any button to wake it up before making adjustments.

NOTE: Temperatures may fluctuate depending on whether the interior light is ON

or OFF and depending on the position of the bottles.

Lock or Unlock the Control Panel

To LOCK the control panel:

1. Simultaneously press the Power and Lighting buttons.

2. The control panel will beep and the LOCK icon will illuminate.

3. The control panel will ‘sleep’ after left untouched for 10 seconds. Touch any

button to wake it up before making adjustments.