Warranty

11
Setting the Temperature Control
NOTE: The temperature display will show the set temperature when the wine cellar
control panel is unlocked and actual temperature when the control panel is locked.
1. Make sure power cord is connected to a properly grounded outlet.
2. Turn the power ON by pressing and holding the POWER button for 3
seconds.
3. Press the Temp Set control button. The Upper Zone temperature display
will start flashing.
4. Repeatedly press the Temp Up or Temp Down control button until the
desired temperature is achieved. Temperatures decrease 1°F with each
push of the button.
5. Press the Temp Set control button again to program the Lower Zone, the
temperature display will start flashing.
6. Repeatedly press the Temp Up or Temp Down control button until the
desired temperature is achieved. Temperatures decrease 1°F with each
push of the button.
7. IN ORDER FOR THIS UNIT TO FUNCTION AT OPTIMUM LEVEL, THE UPPER
ZONE SHOULD BE SET AT LEAST 4°F COLDER THAN THE LOWER ZONE.
NOTES:
 Temperatures may fluctuate depending on whether the interior light is ON or
OFF and depending on the position of the bottles.
Lock or Unlock the Control Panel
To LOCK the control panel:
1. The control panel will lock automatically when left untouched for 10 seconds.
2. The control panel will beep and the LOCK icon will darken.
To UNLOCK the control panel:
3. Press and hold the LOCK button for 3 seconds.
4. The control panel will beep and the LOCK icon will darken.