User manual

USER MANUAL WINE IN25 Page 11
2.2. Installing the wine conditioning unit
- Place the appliance on the brackets
- Screw the 4 screw-washer M6 (supplied
with the unit) using a key 10
2.3. Ducting connection
2.3.1. Ventilation holes
Outside
Composition of basis kit (possibility to order additional
parts)
- Mark the location of grids on the wall
- Drill 2 holes of 155 mm
- Put the 2 grid casing
ATTENTION ! Each module consists of two grids (blowing and suction).
Care must be taken to adapt the type of grid.
Inside
3
Blowing
grid
hole-
rou
1
Suction grid
hole
2
DETAIL OF GRID ASSEMBLING :
SUCTION
BLOWING