Owner's manual

TrakMax 40 User Manual
Revision 1.0
A solid green LED indicates the charging source is functioning properly. A flashing green LED indicates an
error condition exists. The multi-color LED indicates the particular operating mode and the battery capacity
level.
5.1 C
HARGE CONTROL
Battery Capacity:
<LVD
<LVR, >LVD
>LVR
LED Indication:
Red Orange Green
Figure 5.1: Battery Capacity LED indicators
5.2 LED MODES
If the single color LED or multi-color LED flashes, it indicates an error condition such as over temperature,
over current, low voltage disconnect, reverse connection for solar modules, and over voltage of load. The
green LED’s flash time depends on the condition or function they are displaying; See table 5.2.
Single Color LED
Multi-Color LED
Description
Operation
Mode
State
On
Off
State
On
Off
1 Solid Green
∞
∞
Solid Red
∞
∞
Charge ON (PV>BV), BAT<LVD
NORMAL
2 Solid Green
∞
∞
Solid Orange
∞
∞
Charge ON (PV>BV), LVD<BAT<LVR
3 Solid Green
∞
∞
Solid Green
∞
∞
Charge ON (PV>BV), BAT>LVR
4 Solid Green
∞
∞
Blink Red 1s 1s Charge ON (PV>BV), BAT<LVD
DERATED
5 Solid Green
∞
∞
Blink Orange 1s 1s Charge ON (PV>BV), LVD<BAT<LVR
6 Solid Green
∞
∞
Blink Green 1s 1s Charge ON (PV>BV), BAT>LVR
7
Off
∞
∞
Blink Orange
1s
6s
BAT under voltage
FAULT
8
Blink Green
3s
6s
Off
∞
∞
Over Current
9
Blink Green
2s
6s
Off
∞
∞
Over Temperature
10 Blink Green 1s 6s Off
∞
∞
Over Voltage of Load
11 Blink Green 1s 1s Blink Red 1s 1s PV over voltage
12 Blink Green 1s 1s Blink Orange 1s 1s PV under voltage
13 Blink Green 1s 6s Blink Red
∞
∞
BAT over voltage
14 Blink Green
∞ ∞
Blink Red
∞ ∞
Upon start-up wait 3s.
If >3s, BAT voltage is out of range
Table 5.2: Error Mode Indications
NOTE: When the controller is charging, the green LED will be solid green.
Page 17 of 20
windynation
03/06/2013