CHC-1224-xx User Manual Revision 2.
CHC-1224-xx User Manual Revision 2.0 Table of Contents 1 2 3 4 5 Introduction .................................................................................................................................................. 3 1.1 Features ..................................................................................................................................................... 3 1.2 System Diagram ...............................................................................................
CHC-1224-xx User Manual Revision 2.0 1 INTRODUCTION The WindyNation Solar Panel Charge Controller provides a reliable charging and power management solution for solar power battery systems with many of the features that you would expect in a much higher priced controller. This is made possible by the board microprocessor and embedded intelligent software control.
CHC-1224-xx User Manual Revision 2.0 1.3 SAFETY INFORMATION Please read the installation and operating instructions carefully prior to use. Pay special attention to the IMPORTANT and WARNING statements in the manual. WARNING: Never install during a lightning storm or where unsafe voltages are present. Solar panels produce power when exposed to light. Use caution when handling copper wiring. Do not use with equipment that exceeds the rated power for this device. 1.4 SPECIFICATIONS 1.4.
CHC-1224-xx User Manual Revision 2.0 touching components on the circuit boards. The risk of electrostatic damage is highest when relative humidity is below 40%. 2.2 MOUNTING Mounting is optional; however, the environment must be dry and protected from water. 1. The controller can be mounted on a vertical or horizontal surface. If mounted vertically, the unit should be oriented such that neither end is at the top so foreign material cannot settle into the unit. 2.
CHC-1224-xx User Manual Revision 2.0 1) Connect the Battery Connect the battery wiring to the battery terminals on the charge controller. Note the polarity on the screw-down terminals. The charge controller self-protection feature will prevent damage from reverse polarity connections, but the charge controller will not function until the battery is connected properly. IMPORTANT: A properly sized fuse must be placed in the positive wire connecting the charge controller to the battery.
CHC-1224-xx User Manual Revision 2.0 3 OPERATION 3.1 POWER Once properly connected to a battery and solar panel array, the charge controller will immediately begin operating. When first connected, the Load LED will be off, indicating that the power to the load is off. Press the Power/Mode button to turn on power to the load. Note: The solar power charge controller can only be used with lead acid type batteries.
CHC-1224-xx User Manual Revision 2.0 Note: The output will shut off once there is an overload or short circuit. Disconnect all of the equipment and then wait a few seconds before reconnecting everything. Press the Power/Mode button and the controller will resume working after approximately 10 seconds, or in some instances, it may take a few moments longer. 3.2.1 Charge LED When the connected solar panel is exposed to sunlight, the Charge LED will be green, indicating that the system is charging normally.
CHC-1224-xx User Manual Revision 2.0 3.3.1 Normal Control (Default Setting) Mode Indicator Setting 16 or 6. (6-dot). The load will draw from the battery at all times, and the PV panel will charge the battery when sunlight is available. Press the Power/Mode button again after the mode is set to turn on the load output. Note: In this mode only, the Power/Mode button will turn the load output on and off when pressed. After selecting this mode, make sure the load LED is on, indicating load output. 3.3.
CHC-1224-xx User Manual Revision 2.0 4 0.204 (5.19) 0.249 1210 lbs 21.15 2 0.258 (6.54) 0.156 1930 lbs 33.62 1 0.289 (7.35) 0.124 2430 lbs 42.41 0 (1/0) 0.325 (8.25) 0.098 3060 lbs 53.49 00 (2/0) 0.365 (9.27) 0.078 3860 lbs 67.43 000 (3/0) 0.410 (10.4) 0.062 4860 lbs 85.01 0000 (4/0) 0.460 (11.68) 0.049 6120 lbs 107.22 5 TROUBLESHOOTING AND SUPPORT The Controller requires minimal care.
CHC-1224-xx User Manual Revision 2.0 • • Email: support@windynation.com Write: 398 South Kalorama Street, Unit C, Ventura, CA 93001 For challenging issues or to just ask a question, consider using our FREE Community Forums! Consult our community of DIY'ers for fast answers to all your questions. Post on our Forums: http://www.windynation.com/community/ 5.
CHC-1224-xx User Manual Revision 2.0 LIMITATION, THE IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE WITH RESPECT TO ANY PRODUCTS PROVIDED BY WINDY NATION. NO ORAL OR WRITTEN INFORMATION OR ADVICE GIVEN BY WINDY NATION, ITS DEALERS, DISTRIBUTORS, AGENTS OR EMPLOYEES SHALL IN ANY WAY INCREASE THE SCOPE OF THIS WARRANTY.
