manual

2SAFETY INFORMATION
SAFETY INFORMATION
"CAUTION-To reduce risk of fire, properly exhaust air according to local city building
code(s).
"WARNING-To reduce the risk of fire or electric shock, do not use this fan with any
solid- state speed control device.(Variable Speed Controller)
"WARNING-TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR INJURY
OBSERVE THE FOLLOWING:
a) Installation work and electrical wiring must be done by qualified person(s) in
accordance with all applicable codes and standards, including fire-rated
construction.
b) Sufficient air is needed for proper combustion and exhausting of gases through
the flue (chimney) of fuel burning equipment to prevent back drafting, Follow
the heating equipment manufacturer's guideline and safety standards such as
those published by the National Fire Protection Association (NFPA), and the
American Society for Heating, Refrigeration and Air Conditioning Engineers
(ASHRAE), and the local code authorities.
c) When cutting or drilling into wall or ceiling, do not damage electrical wiring and
other hidden utilities.
d) Ducted fans must always be vented to the outdoors.
e) If this unit is to be installed over a tub or shower, it must be marked as
appropriate for the application and be connected to a GFCI(Ground Fault
Circuit Interrupter)-protected branch circuit.
f) Never place a switch where it can be reached from a tub or shower.
WARNING-TO REDUCE THE RISK OF FIRE, USE ONLY METAL DUCTWORK.
"WARNING-TO REDUCE THE RISK OF INJURY TO PERSONS IN THE EVENT OF A
a
RANGE TOP GREASE FIRE, OBSERVE THE FOLLOWING :
A. SMOTHER FLAMES with a close- fitting lid, cookie sheet, or metal tray,
then turn off the burner.
BE CAREFUL TO PREVENT BURNS. If the flames do not go out
immediately
EVACUATE AND CALL THE FIRE DEPARTMENT.
B. NEVER PICK UP A FLAMING PAN - You may be burned.
C. DO NOT USE WATER including wet dishcloths or towels - a violent
steam explosion may result.
LIGHT BULB INSTALLATION
13
Using the light fixture tool provided, lineup each corner of
the fixture tool in parallel with the notches located on the
outer ring of the light fixture. Twist the outer ring counter
clockwise to unlock the light fixture housing.
WARNING!!!
Check to make sure all power sources are disconnected
before starting any troubleshooting. Safety gloves and glasses
should be worn when working on the unit. Serious injury or death
may occur if safety precautions are not followed.
Step 1
Twist light ring counter-
clock wise to unlock
Step 2
Pull the light upward
Step 3
Push light to left or
right side
Step 4
Remove the light by turning
light counter-clock wise
Light Fixture Tool