TABLE OF CONTENTS 1 Table of Contents Safety Information .............................................................. 2 3 Content Checklist ..................................................................... 4 Measurements ........................................................................... 5 Preparation ................................................................................ 6 Installation ...........................................................................
2 SAFETY INFORMATION SAFETY INFORMATION TO REDUCE THE RISK OF A FIRE, ELECTRICAL SHOCK, AND/OR INJURY OBSERVE THE FOLLOWING: Unit is intended for indoor residential use only. If you should have questions, contact the manufacturer at the address or telephone number listed in the warranty. In case the unit should need to be cleaned or repaired, switch power off at service panel and lock service disconnecting means to prevent power from being switched on accidentally.
SAFETY INFORMATION 3 TO REDUCE THE RISK OF FIRE, OR ELECTRIC SHOCK, DO NOT USE THIS FAN WITH ANY SOLID-STATE SPEED CONTROL DEVICE. Regardless of heat level, never leave any surface materials unattended while operating an open flame. Always turn hood ON when cooking at high heat or when flambéing food (i.e. Crepes Suzette, Cherries Jubilee, Peppercorn Beef Flambé). Depending on amount of usage, clean ventilating fans and filters frequently. Grease should not be allowed to accumulate on fan or filter.
4 CONTENT CHECKLIST CONTENT CHECKLIST 1. CONTENTS INCLUDED a. (1) WS-28TB series(30 or 36 hood assembly b. (1) Lower duct cover (18- c. (1) Upper duct cover (18- d. e. f. (2) Magnetic baffle filters g. h. (1) Screw packet 2. CONTENTS NOT INCLUDED a. WS-28TBEXTDC (Extension duct cover) b. WS-28TBCFMR (CFM reducer) c. Aluminum or metal piping 3. TOOLS REQUIRED (NOT INCLUDED) a. Safety gloves b. Safety glasses c. Electric drill w/ starter bit d. Utility knife e. Spirit level f.
MEASUREMENTS Fig. 1a Fig.
6 PREPARATION PREPARATION 1. BEFORE YOU START **BE SURE YOUR UNIT WILL FIT YOUR CEILING HEIGHT** **DO NOT INSTALL IF DAMAGED** **RETURN OR EXCHANGE WILL BE DENIED IF INSTALLED** a. Be sure you have all the content of your purchase and required tools for this installation. b. Installation may take at least 1 to 2 hours from start to finish. c. Plan to use as few elbows or turns as possible for more efficient air flow. d. Collar size may need to be increased if utilizing a long duct run. e.
INSTALLATION INSTALLATION 1. WALL MOUNT INSTALLATION a. Make sure all preparation steps are completed. b. Determine your ceiling height to see if you need an extension. i. Hood unit height = ii. Duct cover height = 18- (lower) + 18- (upper) iii. Minimumheight (duct cover only) = 18-3/4 c. iv. Maximum height (duct cover only) = 36 v. (OPTIONAL) Extension DC Minimum height = 46-3/4 vi. (OPTIONAL) Extension DC Maximum height = Determine the location you want to install the range hood.(Fig.
8 INSTALLATION 3. COLD WEATHER INSTALLATION (OPTIONAL) a. Check with your local building codes to see if a CFM reducer is an b. Remove the WS-28TB CFMR (CFM Reducer) and inspect for any sign of acceptable alternative to make-up air. defect or damage. (ie. Cracks, broken flips) c. AFTER COMPLETING Step A d. Place the CFM reducer onto the outlet of the unit and seal the connection G of WALL MOUNT INSTALLATION point with aluminum tape. (Be sure it is secure with no opening or gaps) e. f.
INSTALLATION DIAGRAM INSTALLATION DIAGRAM Fig. 2a Fig. 2c Fig. 2b Fig.
10 OPERATION & FEATURES OPERATION & FEATURES 1. EASY ACCESS CONTROL SWITCH (from left to right) a. Button 1 OFF b. Button 2 Low Speed c. Button 3 Medium Speed d. Button 4 High Speed e. Button 5 Light f. Button 6 Delay Shutoff 2. BAFFLE FILTERS a. (2) 14-7/8 10-5/8 baffle filters b. (3) 14-7/8 10-5/8 baffle filters 3. CHARCOAL FILTERS **DO NOT WASH CHARCOAL FILTERS! IT WILL DISSOLVE!!** a. Without charcoal filter b.
CLEANING & MAINTENANCE 11 CLEANING& MAINTENANCE WARNING!!! To prevent the possibility of a fire and explosion, do not use flammable liquids or solvents to clean the unit or any of its parts. Check to make sure all power sources are disconnected before servicing or taking unit apart for cleaning. Please thoroughly clean the unit weekly as stainless steel can rust under certain condition or by improper cleaning. 1. RANGE HOOD a.
12 TROUBLESHOOTING TROUBLESHOOTING WARNING!!! Check to make sure all power sources are disconnected before starting any troubleshooting. Safety gloves and glasses should be worn when working on the unit. Serious injury or death may occur if safety precautions are not followed. WS-28TB Series Light Issue (All not turning on) 1. New Transformer/ Driver replacement is required. Halogen/LED light issue 1. LED may require new fixture or driver. Light Issue (One light not turning on) 1.
PART LIST / REPLACEMENT 13 PART LIST / REPLACEMENT # Description # Description 1 Duct cover bracket 8 Transformer 2 Duct cover 9 Capacitor 3 Hood bracket 10 Motor support bracket 4 Hood body assembly 11 5 LED lights 12 Squirrel cage motor 6 Control switch 13 Baffle filters x 3 (30 x2) 7 Control board
14 WARRANTY / CONTACT US WARRANTY / CONTACT US LIMITED WARRANTY Windster Hoods Inc. warrants its product against defects in material or workmanship as follows: Labor:For a period of one (1) year from the date of purchase, if the product is determined to be defective, Windster will attempt to repair the product, at its option, at no charge. After the warranty period, customer must pay for all labor charges. During the "labor" warranty period there will be no charge for any work done on the purchased model.
WARRANTY / CONTACT US 15 WHAT IS NOT COVERED BY MANUFACTURE WARRANTY 1. Damages resulting from any of the following: a. Improper installation or maintenance b. Any repair, modification, alteration or adjustment not authorized by the manufacturer or an authorized service dealer c. Misuse and/or accidents d. Incorrect electric current, voltage or power supply e. Improper setting of any control (Pressing multiple selections at the same time) f. 2.
