Specifications

b. Wall Mount Installation

a. Decide the location and measure the length of

venting pipe from the hood to the outside. (Fig.12)

b. The less transition, elbows, the more exhaust

power performance of the hood.

Prepare back wall frame with cross framing lumber

(purchase locally) and fix in the appropriation for

secure installation (Fig.13)

Test for proper operation by temporarily wire the

hood before installing.

Attach two rubber stands (included) with two (4*8mm)

screws (included) if necessary, to the back of the hood.

Attach the hood - mounting bracket to the back of the

hood with six (3/16" x 3/8" ) screws (included) (Fig.14)

a. Mark the levelling of the hood position two mounting

screws (not included) on the wall, leaving 1/8 away

from the wall.

b. Align hood-mounting bracket to the screws on the

wall and hook into place as Fig.15, Tighten screws

to secure hood to the wall.

RA-33/RA-34 Series

Fig.12

Fig.13

Fig.14

Fig.15

Rubber Stand

Hood-Mounting

Bracket

ROUND

ELBOW

WALL CAP

PIPE

ROOF CAP

CABINET

HOOD