Specifications

WWW.MANUALS.WS
WWW.MANUALS.WS
BATTERY INSTALLATION & REMOVAL (W/ BATTERY CART)
VGR2 98953 12/18/01
5
WEAR EYE PROTECTION AND PROTECTIVE CLOTHING WHEN WORKING
WITH BATTERIES.
BATTERY INSTALLATION AND REMOVAL
FOLLOW THE PROCEDURES CAREFULLY.
1. Remove the vac shoe hose from tank, lay dome back and slowly open tank to upright position.
2. Install (3) batteries in machine by placing them in battery tray liner provided. (See diagram page 6)
3. Connect battery wires according to diagram on page 6.
INSTALLATION OF BATTERIES
FOLLOW PROCEDURES CAREFULLY, BE SURE TO KEEP HANDS AND
FEET CLEAR FROM ROLLING BATTERY TRAY.
1. Make sure the battery door is open.
2. Roll the Battery Cart up to the front of the machine, (aligning the front of the two frames).
3. Push the cart until the latches lock into the tabs on the front of the machine frame.
4. Pull the handle on the Battery Tray. (This releases the locking mechanism on the cart.) Fig 1 & 2
5. Push the batteries into the machine until the locking mechanism on the frame is engaged. (This can be heard
by a “Snapping” sound.) Fig 1.
6. Press the foot pedal on the front of the cart and roll the cart from the machine.
7. Attach battery cable from the batteries to receptacle on front of machine by pressing down on right hand side
of locking bracket. (p/n 140190)
REMOVAL OF BATTERIES
BEFORE REMOVING BATTERY TRAY PLEASE FOLLOW THE INSTRUCTION SHEET 98439.
If you did not receive this sheet please contact Windsor Industries for this instruction sheet.
FOLLOW PROCEDURES CAREFULLY, BE SURE TO KEEPS HANDS AND
FEET
1. Make sure the battery door is open.
2. Disconnect battery cable from receptacle on front of machine.
3. Roll the cart up to the front of the machine aligning the front of the two frames.
4. Push the cart until the latches lock into the tabs located on the front of the machine. (The tabs cannot be seen
when batteries are installed.)
5. The latches are engaged when a “Snapping” sound is heard. Pull the handle on the tray. (This releases the
locking mechanism on the machine frame.) (Fig 1 & 2) Continue to pull handle until the battery pack rolls and
locks onto cart. (The locking mechanism is engaged when a “Snapping” sound is heard.)
6. Press the foot pedal located on the cart and roll the batteries and cart away from the machine.
!
WARNING:
!
CAUTION:
!
CAUTION:
A
B
C
D
E
F
!
CAUTION:
A
B
D
G
F
A
B
D
G
F
1
2
4
5
140190
(REF)
FIG. 1
Key
P/N
Description
1 VCT CART, BATTERY REMOVAL
2 78243 TRAY, VGRB BATTERY LINER
3 78369 TRAY ASSEMBLY BATTERY
4 02143 (3) BATTERY, 12 VOLT
5 02267 CHARGER, 36 VOLT
* NOTE: ONLY THE NEW “VCT”
CART AND NEW TRAY ASSEMBLY
WILL WORK WITH THE VOYAGER
2. PREVIOUS CARTS AND TRAYS,
IN ANY COMBINATION, WILL NOT
WORK.
C
E