Operating instructions

OPERATION
86309590 (1500) BURNISHER 01/21/09
3-2
HANDLE INSTALLATION
The machine is shipped with handle unassembled.
Follow these steps for installation:
1. Remove handle and deck assembly from carton. 3. Remove bolt, nut and washers (items 4, 5
and 6) from lower block on handle assembly.
Attach links as shown. Tighten bolt and nut
securely, then back off 1/4 to 1/2 turn.
2. Attach handle assembly to base using hardware kit
(86219680 – PRV NO. 47331) (attached to handle
in plastic bag) items 1, 2 and 3. 4. Check handle for movement up and down.
5. Plug motor cord into handle cord receptacle.
NOTE: The spacers (item 1) are required for the
correct operation of the handle. The spacers are
positioned completely inside the pivot holes in the
casting, and are held in place by tightening the bolts
and washers (items 2 and 3 against the spacer.
HANDLE
ASSEMBLY
MOTOR
PLUG
DECK
ASSEMBLY
4
5
6
3
2
1
HOLE
PIVOT
HANDLE
RECEPTACLE