RRB 360 T (QJOLVK )UDQoDLV (VSDxRO 3 6 6 0 06 3
Operator Qualifications Only trained and authorized persons shall be permitted to operate a powered unit. Operators of powered units shall be qualified as to visual, auditory, physical, and mental ability to operate the equipment safely according to the following points. Operator Training Personnel who have not been trained to operate powered units may operate a unit for the purposes of training only, and only under the direct supervision of the trainer.
A powered unit is unattended when the operator is more than 25 ft (7.6 m) from the unit, which remains in his view, or whenever the operator leaves the unit and it is not in his view. Before leaving the operator’s position: A bring the unit to a complete stop; B place the directional controls in neutral; C apply the parking brake; In addition, when leaving the unit unattended: A stop the engine or turn off the controls; B if the unit must be on an incline, block the wheels.
A raise drive wheels free of floor or disconnect battery and use chocks or other positive unit positioning devices; B block chassis before working on them; C disconnect battery before working on the electrical system; D the charger connector shall be plugged only into the battery connector and never into the unit connector. Operation of the unit to check performance shall be conducted in an authorized area where safe clearance exists.
Please read and comply with these original instructions prior to the initial operation of your appliance and store them for later use or subsequent owners. Please read the safety instructions before start-up! Contents OPERATING SAFETY RULES AND PRACTICES. . . . . . . . MAINTENANCE AND REBUILD PRACTICES . . . . . . . . . . . . FIRE SAFETY STANDARD General notes . . . . . . . . . . . Proper use . . . . . . . . . . . . . Safety instructions . . . . . . . Function . . . . . . . . . . . . . . .
Safety instructions Application – – The machine with working equipment must be checked to ensure that it is in proper working order and is operating safely prior to use. Otherwise, the appliance must not be used. If the appliance is used in hazardous areas (e.g. filling stations) the corresponding safety provisions must be observed. It is prohibited to use the appliance in hazardous locations. Drive mode Danger Risk of injury! Danger of tipping if gradient is too high.
Operating and Functional Elements 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 Operating field Steering wheel Lever for seat adjustment Seat (with seat contact switch) Storage area Holding rail for home base Cover Battery charge plug Rear wheel Waste container (both sides) Front sealing strip Side sealing strip Rear sealing strip Roller brush Roller brush access Pedal for raising/lowering bulk waste flap Left side brush (optional) Front wheel Fastener of the side brush Right side brush D
Before Startup Open/ close device hood DANGER Danger of crushing while closing the machine cover. Hence, lower the machine cover slowly. Prior to commissioning, maintenance or adjustment tasks, the appliance cover must be opened. Î Grab the front of the appliance cover and fold it back together with the seat. Î A retaining band keeps the appliance cover in the rear position.
Î Connect pole terminal (red cable) to positive pole (+). Î Screw the connection lines onto the batteries. Î Connect pole terminal to negative pole (-). Note Before removing the battery, make sure that the negative pole lead is disconnected. Check that the battery pole and pole terminals are adequately protected with pole grease. 몇 WARNING Charge the batteries before commissioning the machine. Charge the batteries Danger Risk of injury! Comply with safety regulations on the handling of batteries.
Emergency-stop button – – The appliance has an emergency OFF switch. If this switch is pressed, the appliance will stop abruptly and the automatic emergency brake will be activated. In order to restart the appliance, first unlock the emergency OFF switch, then turn the key switch on and off. Programme selection 1 2 3 Driving Driving to the Place of Use. Side brush and roller brush are raised. Sweeping with sweep roller Roller brush is lowered.
Storage DANGER Risk of injury and damage! Note the weight of the appliance in case of storage. Shutdown Î Empty waste container. Î Push in the waste container and lock it. Î Empty opposite waste container. Turn off the appliance Note: After switching off the appliance, the dust filter is automatically cleaned. Wait for approx. 2 minutes before opening the appliance cover. Î Set programme switch to step 1 (driving). The side brush and roller brush are raised. Î Turn main key to "0" and remove it.
