Operating instructions

INFLEXION
TM
TP-4976401-B 2-4
January 2014
CHAPTER 2
INSTALLATION
Safety Instruction -Trained Personnel Only! Only trained and qualified personnel should perform installation,
adjustments, and servicing. Only a properly trained and qualified certified electrician should perform electric
installations and service.
Safety Instruction -Trained Personnel Only! Only trained and qualified personnel should perform installation,
adjustments, and servicing. Only a properly trained and qualified certified electrician should perform electric
installations and service.
Lifting Hazard! Manually lifting over 55 lb (25kg) is prohibited. In the UK, all lifting equipment must be
thoroughly examined annually by a competent person according to the Lifting Operations and Lift Equipment
Regulations 1998. Equivalent regulations exist in other EU states.
Safety Instruction – Installation! The INFLEXION should be installed on a location that is out of reach from
unauthorized personnel.
2.1 INTRODUCTION
The INFLEXION has been designed to provide for ease of installation. This section of the manual provides the
procedures that must be followed to ensure a successful installation. Be sure to read and understand the entire
installation procedure before you begin.
2.2 TOOLS AND MATERIALS REQUIRED FOR INSTALLATION
Table 2-1 provides a list of tools and materials required to install and test the INFLEXION.
Wrenches Crimping tool or Solder set
Screwdrivers Wire cutter/stripper
½ inch or M12 Mounting Hardware (6 each) Multimeter (to verify power is turned OFF)
Torque wrench Clean Shop Rags
Drill
Hoist (minimum 250 lb capacity)
Table 2-1 Tools and Materials Required for Installation