® Residential Elevator Owner's Manual & Warranty Information Part #72002 Rev.
Table of Contents Introduction ............................................................................... 1 Description of Features ............................................................ 2 Typical Components ................................................................. 3 Operating Instructions -Landing Controls .................................................................. 4 -Car Controls ......................................................................... 4 -Manual Lowering Device .
INTRODUCTION The WINDSOR® Residential Elevator is designed for residences where space is at a premium and larger elevators are not practical. This elevator does not require a machine room or pit and requires only a 7'-8" overhead clearance. The dual cable drum dive unit is located on top of the guide rails. It has a 32" x 48" car with a sliding scissors gate. The lifting capacity is 500 lbs. and travel is limited to 16' and 2 stops.
DESCRIPTION OF FEATURES Learn the location and function of all features before using your WINDSOR Elevator. The dealer should explain the features and operating instructions once the elevator is installed. If the dealer did not explain this to you, please contact them. Landing Controls: Located near the landing door, used to “call” the car to that floor. An optional key switch limits use to authorized persons only. Full operation is explained later.
LOCKABLE ACCESS FOR MANUAL LOWERING DEVICE DRIVE UNIT TRACK DRIVE CABLES CAR SCISSORS CAR GATE HOISTWAY DOOR INTERLOCK SCISSORS CAR GATE (FOLDED) LIGHT SWITCH UP/DOWN BUTTONS EMERGENCY STOP BUTTON HOISTWAY DOOR OPTIONAL KEY LOCK Typical Components 5
OPERATING INSTRUCTIONS The following must be observed at all times: • Do not exceed capacity of 500 lbs. (227kg) • Do not bypass any control sensors. • Do not lean against scissors car gate. • Do not use elevator to transport freight. • Do not operate elevator if it has been damaged. • In case of fire, do not use elevator. -LANDING CONTROLS: To “call” the car to your floor: Press and release the landing control button. The button will illuminate, indicating the car is traveling to your floor.
-MANUAL LOWERING DEVICE: WARNING In the case of a power failure, the car can be manually raised or lowered using the manual lowering device (handwheel) as follows: If drive cables are slack, do not attempt to raise or lower the car. Immediately call your local Access Industries' dealer for emergency assistance. 1) If controls are equipped with a key switch, turn all key switches to the “OFF” position and remove keys. 2) Remove power from the drive unit at the disconnect switch.
-HOISTWAY DOOR INTERLOCKS: Hoistway door interlocks are designed to prevent the door from being opened when the car is not in proper landing position and to prevent operation of the elevator if a hoistway door is open. In case of a power failure, the hoistway doors may be opened by following the procedure below: 1) Insert “crescent shaped” emergency release key through the cover plate on the door and into the interlock. 2) Push downward on key to unlock. Hold key in this position while pulling door open.
MAINTENANCE Regular maintenance is essential in keeping your WINDSOR Elevator in proper operating condition. Please remember you, as the owner of this equipment, are responsible for making sure maintenance and upkeep is performed on a regularly scheduled basis. We strongly urge you to protect your investment by having only an authorized Access Industries' dealer perform all required maintenance, service and repair work. They are trained technicians, qualified to do the job.
TROUBLESHOOTING Before You Call For Service. . . . . . A quick check of the Operating Instructions in this manual may prevent an unnecessary service call. Before calling your authorized Access Industries' dealer for service, refer to the following checklist . . . If Lift Will Not Operate: Check for a blown fuse or tripped circuit breaker at the main circuit box. Verify that the car's emergency stop button is not engaged. If equipped, check that key switch is turned to the “ON” position.
LIMITED WARRANTY POLICY ACCESS INDUSTRIES, INC., 4001 East 138th Street, Grandview, Missouri 64030, warrants to the ORIGINAL PURCHASER ONLY for a two year period on the drive train (the drive train is comprised of the motor and gear) and a one year period on all component parts, commencing with the date of purchase, that each elevator and all parts used in the elevator shall be free of defects in material and workmanship.
consequential damages, or legal remedies, so these above limitations may not apply to you. To make a claim under this Limited Warranty, immediately send to the dealer, who sold you the elevator and has the responsibility for handling your warranty claim, a notice of your claim, setting forth the defect complained of, along with a copy of the invoice or other proof of purchase and the serial number of the elevator. The dealer will notify ACCESS INDUSTRIES.
