Operating instructions

86333220 CS20 43
Maintenance
Drive gear disengaged
Machine can be pushed or towed (slowly).
When disengaged the machine rolls easily. Disengage
on a level surface.
Rotate lever firmly in direction of arrow.
Inclines
When navigating an incline the machine may come to a
stop. Turn the machine off. Wait 5 minutes and start
the machine and proceed up the incline.
Overheating may occur if you do not wait the full 5
minutes.
Machine Tie-Downs
There are two tie points located in front of the rear
wheels on the frame, and a Tie-down wrap point on the
recovery tank. Tie-down devices must be of the proper
type and strength. The combined strength of all tie-
downs must be strong enough to lift two times the
weight of the machine. Tie-downs must be positioned to
prevent the machine from moving forward, backward,
or either side to side. Use all four corners of the
machine with the tie-downs running out opposite direc-
tions. Tie-downs must be attached to the transporting
vehicle securely.
Preparation for Loading/Unloading Trailer
Before loading or unloading machine from trailer,
remove squeegee and scrub brush (pad) to eliminate
interference with ramp.
Scrub head must be in the up position before loading.
When transporting the machine on a trailer or in a truck,
in addition to using tie-downs, be sure to block the tires
to prevent the machine from rolling.
CONNECT
AT
FRAME
VIEW FROM
BOTTOM