Operating instructions

86333220 CS20 33
Maintenance
Do not use a pressure washer to clean around the
brush motors. Use tap pressure only.
To Replace Scrub Brush Motor
With the scrub deck in the lowered position, disconnect
brush motor wiring connector from harness.
1. Disconnect the two(2) connectors from solenoid
valve.
2. Remove squeegee.
3. Remove front bumper.
4. Remove four (4) front bolts connecting deck lifting
arms to front of machine.
5. Lift deck and side deck lift brackets off actuator
lifting pin.
6. Slide deck out from under machine on right side,
orientation is determined from operators view.
7. Remove brush/pad.
8. Remove driver.
9. Remove three (3) screws securing brush motor to
deck.
10. Remove brush motor.
11. Reverse steps to install.