Operating instructions

CLEANING PROCEDURE
Start at wall closest to power outlet. Pull
straight back without pushing down on
handle.
STEP
1
Release intermittent setting or turn off
continuous setting on brush/spray switch
approximately 1 foot before ending
cleaning pass.
STEP
2
1ft.
(30cm)
OFF
Push down on handle to raise vacuum
shoe and brush before moving to the next
cleaning pass. Overlap brush contact
area approximately 1inch.
During operation, observe the following: The
Cadet is equipped with clear internal covers to
facilitate operator viewing of dirty solution and
vacuum air flow.
During operation, observe the vacuum intake
cover. Large amounts of water or foam entering
the vacuum system can damage the vacuum
motor. If you notice either condition, shut down
the machine immediately. Empty recovery
tank and/or add defoamer to recovery tank.
STEP
3
STEP
4
SOLUTION
INTAKE COVER
VACUUM
INTAKE COVER
1in.
(25mm)
CADET 86038220 03/16/07
3-8