Automatic Scrubber User's Manual

ManualsBrandsWindsor ManualsVacuum Cleaner10066240

MAINTENANCE

86221970 17” SCRUBBER 01/03/07

4-5

REPLACING OR REMOVING SCRUB BRUSHES

1. Turn the machine off.

FOR SAFETY: Before leaving or servicing the

machine; stop on level surface, turn OFF

machine.

2. Raise the scrub deck up by pushing down on the

pedal.

3. Locate the brush reverse switch on the rear of

the panel. Press to activate the motor then

release to disconnect brush driver.

4. Tilt and pull machine back to expose brush

driver.

INSTALLING SCRUB BRUSHES

1. Turn the machine off.

FOR SAFETY: Before leaving or servicing the

machine; stop on level surface, turn OFF

machine.

2. Tilt and push machine over brush driver. The

brush centering bracket will position the brush

driver.

3. Lower the scrub deck by pushing the pedal

down and to the left.

4. Locate the brush switch and turn on.

SQUEEGEE BLADES

The front squeegee blade allows solution to pass

through channels in the blade into the squeegee

assembly while maintaining vacuum to provide lift.

The rear blade wipes the floor to a near dry

condition. It is important the rear blade be in good

condition to properly do its job.

Check both the front and rear squeegee blades for

damage and wear each day in the pre-run check.

Change the front blade if it is torn or has an uneven

edge. Change the rear blade if it is less than 1/2 the

original thickness.

TO REMOVE SQUEEGEE ASSEMBLY

1. With the squeegee in the up position, turn the

machine power off.

2. Loosen both squeegee knobs and pull squeegee

assembly rearward from the lifting carrier.

3. Inspect or repair as necessary and reinstall.

TO REPLACE SQUEEGEE BLADES

1. With the squeegee in the up position, turn the

machine power off.

FOR SAFETY: Before leaving or servicing

machine; stop on level surface, turn off machine.

2. Remove the squeegee assembly from the

machine. Remove all screws and remove blade

retainer strap and remove squeegee blade.

3. Replace squeegee blades as required.

4. Install squeegee blade.

5. Install squeegee retainer strap.

6. Install all screws starting from center and

working to ends.