User's Manual

Gateway
Doc No. SPL-EDGE Gateway_UM Rev 1.1
Date: July 23, 2021
6
1.3 Indicators
There are various LED indicators located on the Gateway PCB inside the Metal Enclosure, refer to Table 1-2 to
understand its functions and figure 1-2 for their locations.
LED
No.
State Color Function LED ‘ON’ Status
1 ON Green 3.3V supply Indication OK and with limits
2 ON Green 5V Isolated supply Indication OK and with limits
3 ON Green 3.3V Isolated supply Indication OK and with limits
4 ON Green 6.5V supply Indication OK and with limits
5 ON Green 5V supply Indication OK and with limits
6 ON Green 3.8V supply Indication OK and with limits
7 ON Red Input supply fault indication Faulted and outside limits
8
On
transmission
Yellow Network status light Network Communication Active
9 ON Green Device status light Gateway Active
10 ON Green Debug UART Tx and Rx
Upper LED – Gateway transmitting
Lower LED – Gateway receiving
11 ON Green 1.8V supply Indication OK and with limits
1.4 Operations
Once installed and initial operation has been verified, long-term user interaction with the Gateway is not
required.
When applying initial power to the Gateway, the installer should verify proper operation by calling Windrock
and asking for Gateway Installation Support.
WARNING: If the SPL-EDGE-AB-C-D-XXX Gateway is not operating properly, then unit must be returned to
Windrock for repair service. Contact your sales representative or Windrock directly at
[e-mail]
or 1-865-330-1110.
AVERTISSEMENT: Si la passerelle SPL-EDGE-AB-C-D-XXX ne fonctionne pas correctement, puis doit être
renvoyé à Windrock des réparations. Contactez votre représentant commercial ou Windrock directement à
[e-mail]
or 1-865-330-1110.
Figure 1-2 –LED Locations
Table 1 - 2. Status Indication