User's Manual

Gateway
Doc No. SPL-EDGE Gateway_UM Rev 1.1
Date: July 23, 2021
5
1. Product Description
1.1 Gateway
THE SPL-EDGE-AB-C-D-XXX GATEWAY CONTAINS NO USER SERVICEABLE
COMPONENTS. ANY ATTEMPT TO MODIFY THIS DEVICE, USE FOR OTHER THAN ITS
INTENDED PURPOSE, OR SUBSTITUTION OF COMPONENTS MAY DAMAGE THIS DEVICE
LEADING TO UNRELIABLE OPERATION AND DECREASED PROTECTION FOR THE DEVICE
BEING MONITORED.
LA PASSERELLE SPL-EDGE-AB-C-D-XXX NE CONTIENT AUCUNS RÉPARABLE. TOUTE
TENTATIVE DE MODIFICATION DE CET APPAREIL, UTILISER POUR LES AUTRES QUE SA
DESTINATION, OU LA SUBSTITUTION DE COMPOSANTS PEUT ENDOMMAGER CET
APPAREIL MENANT À PEU FIABLE, OPÉRATION ET UNE DIMINUTION DE PROTECTION
POUR LE DISPOSITIF SURVEILLÉ.
1.2 Connections
The Gateway utilizes a single piece antenna which has the capability of WiFi/BT, LTE and GPS communication.
For the details on antenna cable assembly, see section 2. In addition, the gateway provides M.2 slots for
feature extensibility which can include other optional wireless communications.
For models with cellular service, a universal SIM card has been installed in the gateway. The SIM card has
been pre-configured with the ability to communicate with cellular providers in the intended country of use.
The Gateway is produced in several models to accommodate the needs of different customers, based on the
country in which the gateway will be used and also on other customer requirements. Some models are
configured to upload data via a cellular network with the possibility to use an Ethernet-based local network
connection instead. Other models are restricted to an Ethernet connection and do not have cellular service
configured at all.
4G LTE Antenna - The Gateway board has two SMA female connectors to connect the 4G LTE antennas.
(See section 2.1 for location of SMA jacks on PCB).
WiFi Antenna – The Gateway board has one SMA female jack which is used to connect WiFi/BT antenna.
(See section 2.1 for location of WiFi/BT SMA jack)
GPS Antenna – The Gateway board has one SMA female jack which is used to connect GPS antenna.
(See section 2.1 for location of GPS SMA jack)
USB – The Gateway board has provision of 1 USB port. (See section 2.1 for location of USB port.)
Power Input - Power is applied via the integral power cable. NOTE: EQUIPMENT SHALL BE POWERED BY
AN APPROVED SELV LPS POWER SOURCE. Refer to Gateway Datasheet for details.
The gateway enclosure comes with option to connect to a local Ethernet. For models not intended for use with
a cellular network, this Ethernet connection must be connected to a local network. For models intended for
use with a cellular network, it is possible to configure this Ethernet connection to be used as the primary uplink
and the cellular network as a backup. The Ethernet cable is not part of standard accessories provided by
Windrock. Contact Windrock and ask for Gateway Installation Support to arrange such a connection.
WARNING – EXPLOSION HAZARD – DO NOT DISCONNECT EQUIPMENT UNLESS POWER HAS
BEEN SWITCHED OFF OR THE AREA IS KNOWN TO BE NON-HAZARDOUS.
ADVERTISSEMENT – RIAQUE D’EXPLOSION – AVANT DE DECONNECTOR L’EQUIPMENT,
COUPER LE COURENT OU S’ASSURER QUE L’EMPLACEMENT EST DESIGNE NON DANGEREUX.
Figure 1.1: SPL-EDGE-AB-C-D-XXX