User's Manual

LED Status Indicators
Idle: No LEDs. Power saving mode.
Standby: Green LED flashes every 2 secs.
Headset ready to make/receive calls
Make Call: Green LED on, red LED
flashing – 0.5s
Pairing: Red and green LEDs flash alternately
Connected: Green LED permanently on
This guide was prepared by:
EskTech Ltd
24 Norfolk Road, Carlisle,
Cumbria, UK, CA2 5PQ
Tel: [phone]
Fax: [phone]
Email: [e-mail]
Web: www.esktech.com
© EskTech Ltd 2002
Summary of Controls
Controls: You can control the headset using the single,
multifunction button. To check the status of the headset
you need to view the two LEDs (one red, one green)
and listen to the warning tones using the earpiece.
Switch on: Press button once. The green LED will flash
and a low-to-high tone will be heard.
Switch off: Press button until a high-to-low tone is
heard. Both LEDs switch off.
Pairing: Press and hold the button for 8 seconds – until
the green and red LEDs flash alternately – then release
the button.
Cancel Pairing: Press and hold the button for 8 seconds
- until both LEDs are off – then release the button.
Answer a Call: Press the button once.
Reject a Call: Press and hold the button – until the ring
tone stops.
Mute: Slide and hold the button. Green and red LED
on.
Reset: Press and hold the button for 10 seconds. You
will hear a rising then a falling tone. Both LEDs will
flash on and off simultaneously.
Volume Control: Rock the button in either direction to
increase or decrease the volume
.
Bluetooth Headset
Quick Start Guide for
Mobile Phone Use
Char
g
er socke
t
Ear
p
iece / mic. socke
t
Decorative rin
g
Status LEDs
Multifunction button