Installation Guide

CAUTION: Before starting installation, disconnect the power by turning off the circuit breaker or removing the
fuse at fuse box.
Step 1: Remove the screws from the switch box to allow easy wiring. (Fig.1)
Step 2: Remove and discard the center plug from the switch box plate. Attach the light kit to the switch box
plate by feeding the wires and threading the light kit the through the hole of the switch box plate, secure it to the
switch box plate using the nut and lock washer. Be sure it is tight enough to prevent the light kit from vibrating
loose. (Fig.1)
Step 3: Make the wire connections as follows and secure with the wire nuts provided:
- Connect white wire from the fan to white wire from the light kit.
- Connect blue wire from the fan to black wire from the light kit.
Setp 4: While holding the switch box plate, slide the switch box plate up against the switch box and align the
screw holes. Secure the switch box plate to the switch box using the screws removed earlier. (Fig.2)
CAUTION: Make sure that the wires are not pinched between the switch cup and the switch cup plate.
Setp 5: Install 2 x 13W E27 CFL (Included). DO NOT EXCEED MAXIMUM WATTAGE RATING.
Setp 6: Attach the glass shade to the light kit by twisting tightly. (Fig.3)
Read and save these instructions
Screw
Screw
Switch box plate
Switch box
Lock washer
Metal nut
Glass shade
13W E27 CFL
Light kit
Light kit
Center plug
Light kit
FIG. 1 FIG. 2 FIG. 3
Black wire
Blue wire
White wire
Wire nut
MODEL:KG100