Specifications

41
in.xe™
instructions
Up/Down key
Use Up or Down key to set
desired water temperature.
The temperature setting will
be displayed for 5 seconds to
confirm your new selection.
The "Set Point" icon indicates
that the display shows the
desired temperature, NOT the
current water temperature!
98
Programming the system
Depending on system configu-
ration the system performs
either purge cycles or filter
cycles.
Programming filter cycles
To program the filter cycles, you
must enter these parameters:
duration and frequency. During
a filter cycle, pumps & blower
run at high speed for one min-
ute to purge the plumbing.
Pump 1 or CP then runs at low
speed for the remaining of
the cycle.
Setting filter cycle duration
Press and hold Light key until
the display shows
dxx, with "xx"
representing the duration in
hours. (Default: 2 hours).
Use Up or Down key to change
setting.
0 = no filtration
24 = continuous filtration
Note: it's not recommended to
set this to "0".
Off Mode
This mode allows you to
stop all outputs for 30 min-
utes to perform a quick spa
maintenance.
Press and hold
Key 1 key for
5 sec. to activate the Off mode.
Quick press
Key 1 key to reac-
tivate the system before the ex-
piration of the 30 minute delay.
While the Off mode is engaged,
the display will toggle between
OFF and the water temperature.